WE M4/SCAR barrels

[freon]

Thats right buddy!

[Mongoose]

Any guides out there with rough guesses on the FPS differences with valve locations?

[freon]

Mongooose, valve placement is an art not a science. You just have to figure out where you get the right FPS at and put some loctite on it.

Coincidentally I got my EdGi prototype barrel for my WE M4, aside from a little problem with the slot that holds it to the hop assembly, the gun is pin-point accurate. I'll be getting a replacement barrel sometime this week and I'll be putting it through its paces soon.

Its 6.00mm inner diameter smooth bore and extremely well made despite a small flaw in the slot. Like I said, I'm getting a replacement so we'll see how that turns out. After that, you can place your orders

[Mongoose]

So I take it the barrels are ready for production?

[skyrookie]

any update on your new barrel freon ?


greetz,

[west]

there is a Npas kit made for the we scar that will raise or lower the fps from 250 to 500 I dont remember the web sight, I googled we scar gbb and it came up. I also saw a video on the installation. the adjustment is made with a key.

[shutter]

NPAS kits can be found on evike or airsoftgi. I recently turned both my SCAR and M4 into a sniper type weapon and I installed a uni directional valve with adjustable NPAS kit and the difference is night and day. I also installed a heavier recoil buffer and spring on the M4 and it feels like a 9mm (on warm days) on my shoulder instead of a piddly 22.

[Mongoose]

Shutter, do you have an extended barrel in your SCAR?

[shutter]

I don't have one on the Scar, but I did install one on my M4 recently.